Before installing and using please read the following warning
carefully.
Ø The recorder uses DC power supply, input DC range is 8V-36V,
Please pay attention to VDD and GND when connecting the power, DO NOT make DVR short-circuit.
Ø After DVR connect camera, the initial power must be over 30W
(Specific power consumption will vary depending on the external
equipment),Power Supply must be provided over 30W.
Ø From the power supply to DVR all power cables must ensure that
the diameter is thick enough to withstand more than 60Watts. For
example, when the vehicle power supply output voltage is 12V , the source
line must be able to withstand 5Amps or more;
Ø Install the equipment in the dry environment, avoid damp, drip,
water spray,etc.
Ø To extend the life of the equipment, please install the equipment
in the weak vibration part of the vehicle;
Ø The equipment should be installed in the vehicle interior
ventilation, do not install in the closeness environment;
Ø Ensure that equipment away from the heat source in the vehicle,
the equipment can not have sundries piled up;
Ø As far as possible from the electromagnetic environment, away
from the strong interference environment;
Ø Ensure that passengers or drivers can not interfere and damage
any component of the equipment.
Ø The installation and all materials must bear the fuselage weight.
Ø It is recommended that the power cord wear heat resistance, waterproof and oil proof casing which can prevent the short circuit or break up due to the long time vibration in the vehicle.;
Ø In the absence of professional guidance, please do not open or
remove the equipment.
